Start a new topic

Voltage present at output

I have just purchased a Basic R3 and found the following fault. 

I have the device connected to my LED lights. The device is connected ewelink with the latest standard firmware. The problem comes when i switch the LED lights off. The LED does not run off fully. When measured  the voltage at the output measures between 1 and 6 volts.

Does anyone know if this is firmware controlled or just a hardware issue.

Is there any method instructions to convert the relay into dry contacts specifically for the R3. in certain videos they remove resistors and in other videos they dont. I need to know what to do as i do not want to waste electricity.



Try to change L1 and N on the Inputside of the R3. If that had a plug turn this 180° in the socket. Could help sometimes.


Login or Signup to post a comment