I have 3 lamp drive by rf remote 1 button for on 1 button for off each, they are correctly associated with RF Bridge (3 RF remote with 2 buttons).
I want to create a scene to trigger all the lamp on, but I CAN'T in "execute" i can only add 1 RF bridge button no more, when i try to add more the app eWeLink substitute the other command. It is normal? There is a solution?
I have also a couple of lamps (powersupply via SonOFF Basic, S20, S26 and SonOFF RF)
And I use a scene for "Entering the room" (which executes POWER ON for some of these items)
and a second one for "Leaving the room" (this one shuts down all my devices).
Both actions are triggered by one 433MHz Wall-mounted Switch (ON/OFF).
But to the bridge this switch is registered as two different ALARMs.
The problem is, that my Switch is a double-Switch: a left half with ON/OFF and a right half with ON/OFF.
And so the full bridge is occupied by this single Switch.... :-(
Today a third SonOFF RF Bridge arrived and so I tried to define one side of my switch as an Curtain:
ON/OFF as usual, STOP ignored.
But in this case I can't use it as a trigger to my scene any more.
Why isn't it possible to use Curtain-Buttons as a trigger in a scene???